Set Up Your WristPop

The Swatch x AP Royal Pop Lan Ba in a WristPop case-strap, held in hand

Now It Fits.

Your Royal Pop is about to become a wristwatch.

Three steps, about ten minutes, and the only tool you need from home is a pair of scissors. Everything else is in the box.

3 steps ~10 minutes Scissors only Fully reversible

In the box

TR90 case frame, in your colour and crown position
FKM rubber cut-to-size strap
Deployant clasp with a colour-matched cover
Two spare clasp covers
Three spring bars and a spring bar tool

The setup

Three steps, ten minutes.

1

Step one

Clip in your Royal Pop

The case frame snaps around the watch. Rest your Royal Pop into the frame dial up, then press gently along the edge until it sits flush. It gives the watch what it never had: lugs.

No tools, no drilling, no glue, no permanent modification. The fit is non-destructive and fully reversible, so you can return the watch to its original form whenever you like.

Watch: fitting and wearing, 32 seconds. The same film covers step 3.

2

Step two

Cut the strap to your size

The strap is cut-to-size, the same system as our CTS range worn by thousands. You trim it once, and it fits like it was made for you. The method:

TEST   Fit the strap to the case, place the watch on your wrist, and overlap the two ends. Count the segments you need on each side. Wrists are not symmetrical, so expect the two sides to differ.
CUT   Cut along the groove with scissors, one segment at a time. Leave one segment more than you think you need on the first pass. Count twice, cut once.
CHECK   Fit the spring bar into the last hole, click the strap into the clasp, and try it on. A little loose on the first attempt means you are on the right track. Repeat until the clasp sits centred and snug.

The full cutting film, start to finish.

Read the full cutting guide

3

Step three

Close the clasp and go

The deployant clasp closes with a leaf spring, no buttons and no pushers. To put it on, pinch one side of the clasp closed, then the other. To take it off, pull up on either side and it springs open. Close it slowly the first time so you get a feel for the snap.

The clasp cover is colour-matched to your case, so on the wrist the whole set reads as one watch.

Change the look in seconds

The strap releases with the quick-release spring bars, so one watch never has to stay one colour. Every strap colour is made for this case.

See the full range

If a part breaks

If the case frame or the clasp cover breaks, we replace it free, for as long as you own it, no questions asked. Two spare clasp covers already ship in your box, and every wearing part is available on its own.

Read the WristPop Guarantee

We are here after you buy

Stuck? A real person replies.

Tap the chat bubble in the corner of this page for live chat, email support@delugs.com, or walk into either boutique, Raffles in Singapore or Hong Kong, and we will set it up with you.